All devices previously learned such as remote controls, magnetic contacts, opening detectors or
infrared sensors, can be deleted
To clear memory proceed as follows:
With the system disarmed, open the bonnet and leave it open
.
.
!
!
!
!
!
Turn ignition key “ON-OFF” - “ON-OFF” - “ON-OFF” - “ON”.
After the 4th rotation, leave it “ON”.
.
Close the bonnet.
.
To confirm it has entered in delete mode, the system gives 2 acoustic signals (one high and one
low-pitched), the turn indicators flash once and the LED turns ON
To clear the memory, leave the bonnet closed for at least 8 seconds
!
17.0 - DELETING STORED DEVICES
To carry out the operation successfully, make sure the required electrical connections
(bonnet switch and ignition) are complete.
To carry out the operation successfully, make sure the required electrical connections
(bonnet switch and ignition) are complete.
!
!
!
!
!
Turn ignition key “ON-OFF” - “ON-OFF” - “ON-OFF” - “ON”.
At the 4th rotation, leave it “ON”.
.
To confirm it has entered in the learn mode, the system gives 2 acoustic signals (one high and one
low-pitched), the turn indicators flash once and the LED turns ON
!
!
!
!
!
The system is ready to receive the device codes.
button “1”
.
R
“OFF”.
According to the device to be stored in memory either press
on the remote control, make
the magnetic contact transmit (bring contact and magnet close together and then move apart),
press the button on the opening detector or make the infrared sensor transmit (see sensor
instructions)
Every time a device is learned, there is a high-pitched signal and the status LED turns OFF briefly to
confirm the procedure.
epeat this procedure to program other devices.
Turn ignition key
The end of the procedure is confirmed by a low-pitched audio signal, a flash of the turn indicators
and the status LED turns OFF.
!
16.0 - ADDING NEW DEVICES
PAGE 16 - INSTALLER MANUAL
INSTALLER MANUAL - PAGE 17
Radio devices can only be learned by 93XR systems
Storing memory is for 55 devices
If an extra device is added, it automatically deletes the first device stored in the alarm
memory
.
.
.
!
To activate the procedure proceed as follows:
With the system disarmed, open the bonnet and leave it open
!
.
The following operations must be carried out within 4 seconds otherwise the procedure
is invalidated.
The following operations must be carried out within 4 seconds otherwise the procedure
is invalidated.
Do not modify bonnet position otherwise
.
all devices, previously saved, will be deleted as
described in the next paragraph
!
!
!
!
!
.
”.
The status LED turns OFF when the devices are deleted
Turn ignition key “OFF
A long low-pitched acoustic signal will confirm the end of the procedure.
!
!
The bonnet must be kept closed for at least 8 seconds otherwise the devices will not
be deleted.
