12.0 - VEHICLE CODE PROGRAMMING
I
”.
f the system is intended to work via CAN-BUS, it must be configured according to the vehicle on which
it is installed.
To help you understand the coding procedure, here below is an example illustrating the configuration
procedure.
In this case the code used is 1-0-3 which hypothetically corresponds to a “FIAT XXXXX
PAGE 12 - INSTALLER MANUAL
INSTALLER MANUAL - PAGE 13
Connect the harness connectors to the alarm connectors.
.
Press and hold the button shown below, until the LED lights up
R
.
elease the button, the LED switches off
After 3/4 seconds, the LED starts a flashing sequence; count the flashes.
Press the button at the 1st flash, which corresponds to number “1”.
After 4 seconds, the LED starts blinking again.
Press the button at the 10th flash which corresponds to number “0”.
After another 4 seconds, the LED flashes the third sequence.
Press the button at the 3rd flash which corresponds to number “3”.
Press
Press
Press
FIRST
FLASH
TENTH
FLASH
THIRD
FLASH
3-4 seconds
Press the vehicle remote control lock/unlock buttons to make sure the alarm system works
properly.
Eventually disconnect the 8-way connector and reconnect it after a few seconds.
10 FLASHES AND A
SHORT PAUSE
3 FLASHES
1 FLASH AND A
SHORT PAUSE
When the last digit is entered, the alarm system “repeats” the entered code.
e area).
A separate leaflet, included in the alarm packaging, lists all the available vehicles
(codes are updated at packaging time).
Up-to-date information on supported vehicle models can be found at: www.gemini-
alarm.com (privat
!
!
The system has a LED indicator that signals any wrong vehicle code inserted.
The code must range between 100 and 235 otherwise the LED on the unit blinks
repeatedly and the procedure is interrupted.
The previously inserted code remains stored.
The procedure is also invalidated if the LED blinks more than 10 times.
In this case there is no optical warning, the procedure is simply interrupted.
In either case, repeat the whole procedure.
13.0 - SELF-LEARNING OF TURN INDICATOR FLASHES
In order to arm/disarm via the turn indicators, the system must learn the vehicle lock (arm) and unlock
(disarm) signals.
Connect the WHITE-ORANGE wire to the turn indicators and proceed as follows
Disconnect the 8-way harness connector from the 8-way alarm connector.
Turn ignition key “ON”.
Connect the 8-way harness connector to the 8-way alarm connector; the LED turns ON steady.
urn ignition key
lose all doors and press the lock button on the original remote control.
When the turn indicators stop flashing, a high-pitched signal confirms the arming flashes have been
learnt.
Press the unlock button on the original remote control.
When the turn indicators stop flashing, 2 high-pitched signals confirm the disarming flashes have
been learnt.
This completes the procedure
!
!
!
!
!
!
!
:
T
“OFF”.
C
.
!
!
To cancel the programming of the turn indicators, reset the system (see
chapter 19.0).
!
