14.0 - SYSTEM PROGRAMMING
The t
E
able below applies to the system programmed in “standard configuration”.
very time you enter the programming procedure, the alarm resets to the default settings.
15.0 - SYSTEM PROGRAMMING EXAMPLE
.
LED button is pressed, a high or low tone signal sounds
Here below is an example that illustrates the steps to follow to modify the programmable functions.
As mentioned before, every
the functions, while the
them
When ignition is turned OFF-ON or the
.
key rotation disables
LED button enables
FUNCTION
STATUS
Disabled
Enabled
Disabled
Disabled
Disabled
Enabled
-----
Exclusion of arming/disarming optic signals
Exclusion of arming/disarming acoustic signals
System passive arming
Enabling of coded output for self-powered siren
Door input - positive
Optical pulse signal
For Gemini only, turn ignition key
Optical flashes activated by connection to the Hazard switch will ONLY turn on during an
alarm condition.
The alarm system BLUE wire MUST be connected to the Hazard switch.
In this case, do not connect the alarm ORANGE wires (see chapter 10.3).
!
A lack of power during electrical system maintenance, will not affect the programming.
Every turn of the ignition key
the selected parameter and moves to the next one until the
programming procedure is completed.
The programmable parameters are briefly described here below while the programming instructions
are illustrated in the next paragraph.
disables
14.1 - OPTIC SIGNALS
This parameter activates optic signals when alarm is armed (1) and disarmed (2).
If the vehicle already has optical lock/unlock signals, the turn indicators alarm flashes
should be deactivated.
14.2 - ACOUSTIC SIGNALS
14.3 - PASSIVE ARMING
14.4 - ENABL
14.5 - DOOR SWITCH POLARITY SELECTION
14.6 - OPTICAL PULSE SIGNAL/SELF-POWERED SIREN
This parameter activates acoustic signals when alarm is armed (1) and disarmed (2).
(art. 7725).
This parameter modifies the alarm input signal (positive or negative) according to the signal generated
This function activates the optical
This function arms the system 60” after ignition is switched off and the last door is opened and closed.
If a door is opened during this lapse of time, the procedure is interrupted and will resume when the
door is closed.
by the door switch.
signals according to the connection made; only for vehicles where
hook-up is to the Hazard switch.
ING OF SIREN (7725) OUTPUT
This parameter enables the relative output (20-way connector, position 13, PINK wire) to activate the
self-powered coded siren
PAGE 14 - INSTALLER MANUAL
INSTALLER MANUAL - PAGE 15
!
If the function is disabled, under normal operating conditions, the blue wire carries a negative signal;
during an alarm cycle, there is a lack of negative.
In both cases, system moves on to the next function.
signals
.
Repeat steps above to enable or disable the other functions.
When the last function is configured (either with the LED push-button or the ignition key), in
addition to the confirmation tone, the system gives 2 low-pitched and 1 high-pitched acoustic
and the turn indicators flash twice.
These last two signals indicate the end of the programming procedure
With the alarm disarmed,
turn ignition key “ON” and
press the button on the status LED,
release
the button within 2 seconds.
Two acoustic signals (a high and a low-pitched sound) and two flashes of the turn indicators
confirm that the system is in program mode.
OFF-ON
Boop
Beep
Turn ignition “OFF” and then back “ON” to
disable the function.
A low-pitched acoustic signal confirms the
operation.
Press the button on the LED
.
.
once to activate the
function
A high-pitched acoustic signal confirms the
operation
OR
ON
PRESS
RELEASE
