FADER REPLACEMENT:
SPECIFICATIONS:
1. UNSCREW THE FADER (B) SCREWS. DO NOT TOUCH INSIDE
SCREWS (C) CAREFULLY REMOVE OLD CROSS FADER AND UNPLUG
CABLE (D)
2. PLUG IN THE NEW CROSS
FADER INTO CABLE (D) AND
PLACE BACK INTO MIXER.
3. SCREW THE CROSS FADER TO
MIXER WITH THE FADER PLATE
SCREWS (B)
4. REPLACE THE FACE OF THE
MIXER AND SCREW THE FOUR
SCREWS BACK IN AND REPLACE THE FADER KNOBS.
INPUTS:
Phono:..........................................................................3 mV, 47 KOhm
Line:.........................................................................150 mV, 27 KOhm
MIC 1, 2, & 3:.............................................1.5 mV, 2 K Ohm Balanced
Bass:..........................................................................................± 12dB
High:...........................................................................................± 12dB
OUTPUTS:
Amp/Booth:.............................................................0 dB 1 V, 400 Ohm
Max:........................................................................20 V Peak-to-Peak
Rec.............................................................................150 mV, 5 KOhm
Zone........................................................................0 dB 1 V 400 Ohm
Balanced..................................................................6 dB 2 V 400 Ohm
GENERAL:
Frequency Response:.....................................20 Hz - 20 KHz +/- 2 dB
Distortion:....................................................................................0.02%
S/N Ratio:.................................................................Better Than 80 dB
Talkover Attenuation:..................................................................-16 dB
Headphone Impedance:...........................................................16 Ohm
Power Source:............................................115/230 V, 60/50 Hz, 20 W
Unit Dimensions:.................................................W 19" x H 4" x D 9.1"
..................................................................(482.6 x 100.6 x 231.2 mm)
Weight:..................................................................... 10.34 lbs (4.7 kg)
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTIFICATION
FOR IMPROVEMENT
MM-1800/2400
(MM-2400) CONTROLS:
ECHO SECTION:
An echo effect may be applied to the
PGM
, or
MIC 1 & MIC 2
signals by switching the
ECHO ASSIGN
switch from
MIC 1-2
on the
LEFT
, to
OFF
in the
MIDDLE
, to
MASTER
on the
RIGHT
& vice
versa. When using
ECHO
, you may adjust the effect of the
ECHO
by
using the rotary
REPEAT, DELAY
, and
ECHO VOLUME
controls.
To turn the
ECHO ASSIGN OFF
or lower the
ECHO VOLUME
.
SOUND EFFECTS SECTION:
Six different sound effects
(APPLAUSE, SCREAM, COPTER,
SCRATCH, H2O & GLASS)
may be added to your mix by pressing
the
SOUND EFFECTS CONTROL BUTTONS
. The volume of the
effects can be adjusted using the rotary
EFX VOLUME
located
above the
APPLAUSE
effect button. The pitch of the effects can be
increased or decreased using the rotary
SPEED CONTROL
located
above the
SCRATCH
effect button.
32
33
7
