5
4.
MAINTENANCE:
There is no maintenance required for this light. It is desinged to be used only once, meaning that replacement is
necessary if it becomes defective (repairing is impossible).
Before any handling, ensure that there is NO voltage supplied to the lamp.
To replace, unfasten the lamp from the bracket. Ensure the new lamp is of the same model and characteristics as
the one being replaced.
5.
WARRANTY:
The manufacturer warrants this resin filled LED underwater lights against defects in materials and workmanship
for a period of five years from the date of purchase. This warranty does not cover the fixture becoming damaged
due to misuse, accidental damaged, improper handling and/or installation and specifically excludes liability for
direct, incidental or consequential damages. Defects in materials and workmanship are exclusive of the following:
•
The light with less than 252 normal LED has 3 dead LED or less.
•
The light with more than 252 normal LED has 6 dead LED or less.
•
The light has small air bulbs inside the resin on the front side with a size of 9 mm
2
or less, and the number of the
air bulbs is 3 or less.
•
The light has small air bulbs inside the resin on the back side.
6.
SAFETY WARNINGS:
People in charge of assembly should be suitably qualified for this type of work.
As safety measure and to avoid possible risks, in case of the external cable of the LED light was damaged, this have to
replaced only by authorized employers by the manufacturer.
Avoid making contact with the electric voltage.
Comply with the current standards regarding accident prevention.
In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIMMING
POOLS.
All maintenance operations should be performed with the LED light disconnected from the Mains.
Do not handle any electrical components with wet hand.
7.
ASSEMBLY AND FUNCTIONING WARNINGS:
It is not recommended the use of sealing putty in this product and, anyway, you should use only products specifically
conceived to work with ABS, all those products of universal use remain excluded.
The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric
components which have been inserted or handled at locations other than its own premises.
It is responsibility of the installer to ensure that no water gets inside the projector by means of the cables.
Attention: Please note that the Ph of pool water always must be between 7.2 and 7.6.
Содержание SLIM LED
Страница 1: ...GEMAS SLIM LED LIGHTS INSTRUCTION MANUAL ...
