Geko 4401 E -AA/HEBA, Руководство по эксплуатации

Страница: 10 / 21

10
10. During engine operation
When the engine is warmed up, the valve opens automatically (do not push it).
The low oil level warning system prevents the damages of the engine when the level of oil in a crankcase is too low. When the oil level falls below the minimum admissible level, the warning system automa-
tically turns off the engine [in this case, the ignition lock remains in the „ON“ position].
Warning! If the engine has stopped and does not start, check the oil level before looking for a fault.
11. Turning-off the engine
To turn off the engine:
1. Disconnect consumers of electric power, take plugs out.
2. Give the engine to work about 1 min without load.
3. Set the ignition key to the OFF/Aus position (Off).
4. Set the fuel cock to the OFF/Aus position (Off).
12. Custom-order equipment
12.1 Radio device FFS 100 for remote start and stop of the electric plant (option)
The device is made in the form of a compact module Geko-SMD. Due to the small sizes of the transmitter, a user can constantly carry it with him.
The device is intended only for electronic start and not applied in combination with UBC 400.
By using FFS 100, the electric plant can be started or stopped [key should be in the „ON/Ein“ position (On)] from a distance up to 100 m (depending on the conditions of radio wave propagation). The
Geko remote control radio device works in the 433-MHz noiseless band.
Frequency codes FFS 100 are set by DIP switches on the transmitter and receiver. In the delivery condition, switches are in the following positions: 1 = ON; 2 = OFF; 3 = ON; 4 = OFF; 5 = ON; 6 = OFF;
7 = ON. For work, the switches of both devices should be set identically. The positions of switches 8-10 on the receiver must never be changed (factory installation: 8 = ON; 9 = OFF; 10 = ON).
See also electrical connection scheme 100126.
Receiver
DIP switches
DIP switches