14
12.4.1.3 Possible dangers at unforeseen application and inadequate manipulation
High voltage and current!
Danger of death or heavy injury! When working with the device, it is necessary to exclude touches to current carrying parts. All sockets (of any kind) should be joined only when the device is turned off.
Surfaces may be hot. Danger of burn!
*
A touch to the hot details of the case, radiator, etc. can lead to burns.
* Sufficient cooling of built-in components must be ensured. Inadequate manipulation can lead to injuries including burn, squeezing, cut, and shock! Inadequate operation and installation of the certain
components of the drive can lead to injuries under unfavorable conditions.
* Follow general building rules and safety requirements when installing and operating.
* Apply appropriate assembly and transport appliances.
* Take appropriate measures preventing pinching and squeezing!
* If necessary, apply corresponding protective appliances (e.g., goggles, footwear, gloves).
* Do not stand under a suspended load.
* Immediately remove liquids spilled on a floor (danger of slipping).
Protection against an electrostatic discharge / Installation instructions
Take into account when installing electronic modules.Apply corresponding protection against electrostatic discharges.
Warning! Inadequate manipulation with these devices and failure to comply with warnings can lead to material damage, physical injuries, damage by current, or even death.
Dangerous displacements! Unforeseen displacements of the elements of engines lead to danger to life, the possibility of heavy physical injuries, or material damage!
Attention! If a BLC-equipped genset will be started with disconnected battery or reverse connected battery, a 2A-fuse inside the
controlbox will blow. This has to be replaced by authorized personnel.
Dangerous displacements can arise due to the erroneous adjustments of engines. Causes may be different:
* polluted or defective electrical wiring;
*
erroneous adjustment of components;
*
faulty gauges;
*
faulty components;
*
errors in the software;
*
going beyond the operational restrictions.
These defects can be revealed both immediately after installation and a while after the beginning of operation. In order to prevent
accidents, injuries, and material damage due to unforeseen displacements of the details of the engine, corresponding protective
measures must be realized in devices or plants.
Possible additional measures for the prevention of the specified cases:
* do not present in the zone of movement of the elements of a device or a plant;
*
apply sufficiently durable protective barriers and casings;
* before opening the device or access in a dangerous zone, make sure that the device is stopped, and exclude a non-authorized repeated start.
The presence of persons with heart stimulants, metal implants, and acoustic devices near electrical equipment is dangerous to health!
Persons with heart stimulants and metal implants must not be admitted to zones where:
* electric devices and components are mounted, working, or commissioned;
*
the components of engines with constant magnets are stored, repaired, or mounted.
If access to the specified zones is necessary, these persons should preliminary consult with a physician.
2A-fuse (BLC only)
Содержание 4401 E -AA/HEBA
Страница 2: ...2...
