Gehl R135, Руководство оператора

Страница: 109 / 206

105 50940193/DP0415
Never push the “float” button with the bucket or
attachment raised, because this will cause the lift
arm to fall to the ground, which can cause severe injury or death.
Loading Trucks (or Hoppers)
Important: When the self-
leveling feature is on, the tilt
angle of the attachment is kept
constant, relative to the ground
plane, when the lift arm is
raised: when the lift arm is
lowered however, self-leveling is
not activated. See “Self-Leveling
(Option)” on page 101 for more
information about the self-
leveling feature.
1. (Figure 73) Approach the
truck and stop, allowing for
clearance to raise the lift arm
and loaded bucket, and raise
the bucket until the lower
edge of the bucket clears the
truck bed.
2. Drive slowly forward and
stop with the bucket over the
inside of the truck.
3. Tilt the bucket forward and dump the material into the truck bed.
4. When the truck is half-loaded, use the bucket to spread the load evenly.
5. Back away from the truck while tilting the bucket back and lowering the lift arm.
Tips When Loading Trucks
• (Figure 74) The truck and machine work-
ing direction should form an angle of 45°.
• Only raise a full bucket to the height
needed for dumping when you are driving
in a straight line toward the truck.
• Dump with the wind behind you to keep
dust away from your face, air filters and
fans.
WARNING
Figure 73 – Dumping into a Truck
(or Hopper)
1
2
3
Figure 74 – Loading Trucks