page | 93
Input #
The number of the input.
Name
The name of the input. The name of the input can be changed using the
#set_input_name
command or through the
I/O Setup ► I/O Names
page of
the Web interface.
EDID Source
The current EDID source being used.
EDID Name
The name of the EDID.
Clear All
Clears all check marks from the
Copy To
column.
Internal - 1080p 2 ch audio
This mode can be used as a generic EDID. Resolutions up to 1080p Full HD
are supported along with 2-channel audio.
Internal - 1080p Multi ch
Same as above except with multichannel audio support.
External - Output1
Uses the (downstream) EDID of the sink device connected to Output 1.
Custom - Last Output
Uses the EDID from the last output on the matrix. For example, this matrix has a
total of two outputs. If a sink device is connected to
both
Out 1
and
Out 2
, then
the matrix will use the EDID from the sink that is connected to
Out 2
. Likewise, if
a sink device is connected
only
to
Out 2
, then the EDID from
Out 2
will be used.
Alternatively, if a sink device is connected
only
to
Out 1
, then the EDID from
Out
1
will be used.
Custom - User
Used to select an EDID from the desired bank and copy it to an input.
To do this, select the bank from the
Copy EDID From
drop-down list.
Next, select
Custom - User
for the desired input, under the
EDID Modes
column. Finally, place a check mark in the
Copy To
check box, then click the
Copy
button.
Advanced Operation
Web Interface
