Gefen GTB-HDFST-848, Руководство пользователя

Страница: 31 / 64

IP CONFIGURATION
27
Confi guring the IP Address
The 8x8 Matrix for HDMI supports IP-based control using Telnet. To set up I
Telnet control, the network settings for the matrix must be confi gured via RS-232.
The default network settings for the matrix are as follows:
IP Address:
192.168.1.72
Subnet:
255.255.255.0
Gateway:
192.168.1.254
HTTP Port:
80
Telnet Port:
23
1. Connect an RS-232 cable from the PC to the matrix.
2. Launch a terminal emulation program (e.g. HyperTerminal) and use the
RS-232 settings listed on page 26.
3. Set the IP address for the matrix using the
#sipadd
command (see page
36 for details).
4. Set the subnet mask using the
#snetmask
command (see page 37 for
details).
5. Set the gateway (router) IP address using the
#sgateway
command
(see page 33 for details).
6. Set the Telnet listening port using the
#set_telnet_port
command
(see page 32 for details).
7. Set the HTTP listening port using the
#set_http_port
command
(see page 30 for details).
8. Set the Telnet username using the
#set_telnet_username
command
(see page 32 for details).
9. Set the Telnet password using the
#set_telnet_pass
command
(see page 31 for details).
10. Power-cycle the matrix to reboot and complete all IP setting changes.
11. After the matrix has rebooted, use the IP address that was specifi ed in
step 3 to Telnet to the matrix.
NOTE: Depending upon the network, the IP address, subnet mask,
gateway (router) IP, Telnet port, and HTTP port will need to be set.
Consult your network administrator to obtain the proper settings.