Gefen EXT-CAT5-1600A, Руководство пользователя, Страница: 10 / 17

7
RECEIVER PANEL LAYOUT
1 RGB Equalization Trim Pots (Trim Potentiometers)
Adjusts the Red, Green, and Blue color components to correct color
convergence / divergence due to varying distances and/or skew variations found
in different brands of CAT-5 cable. Turn the controls to achieve the best color
and picture. If necessary, use the Advanced Features (see page 9) to fi ne-tune.
Note: When turning the Trim Pots, use a small screwdriver or an electronic
device adjustment tool (available at electronics stores). Use gentle force when
rotating Trim Pot controls. Turn controls in both directions if necessary to get
best results. Never force a control if resistance is encountered. Gefen is not
responsible for inoperable units due to broken trim pot controls.
2 Brightness Trim Pot
Adjusts the brightness of the picture.
3 Focus Trim Pot
Adjusts the focus of the picture.
4 Power Indicator LED
This LED will turn RED once the locking power supply has been properly
connected. When the CAT-5 link is established, the LED will be GREEN. When
the Receiver unit is in Standby Mode or Power Saving Mode, this LED will be
RED. (Power Saving Mode is covered in detail on page 9).
5 5V DC Locking Power Connector (threaded jack on rear left of Receiver)
Connects the included 5V DC Locking Power Supply here. Screw in the locking
power connector with hand force only until it stops turning. Do not overtighten.
6 VGA Outputs (2 x HD15 Connectors)
Connect VGA monitors to these ports.
7 Audio Output Connector (3.5mm Mini-Stereo)
Connect the audio from this port to an analog audio amplifi er.
8 CAT-5 Video Link Input (RJ-45 Connector)
Connects the Sender unit to the Receiver unit using CAT-5 cable. Used to
receive the video signal from the Sender Unit.
9 USB Ports (4 x USB 2.0 type “A”)
Connect the USB devices (keyboard, mouse device, etc.) to these ports. The
CAT5-1600A Receiver functions as a 4-port USB 2.0 Hub.
10 CAT-5 USB Link Input (RJ-45 Connector)
Receives the USB signals from the Sender Unit. Connects to the Receiver unit
via a length of CAT-5 cabling.
11 Host Indicator
This LED will turn GREEN when the power and all devices are connected to
the Sender unit. The LED will turn RED if a USB device or monitor has been
disconnected from the Sender unit.