Gefen Pro GEF-DVI-848DL-PB, Руководство пользователя

Страница: 33 / 100

29
IP CONFIGURATION
Configuring the IP Address
This matrix supports IP-based control using Telnet or the built-in Web-based GUI.
To set up IP control, the network settings for the matrix must be configured via
RS-232. The default network settings for the matrix are as follows:
IP Address: 192.168.1.72
Subnet:
255.255.255.0
Gateway:
192.168.1.254
HTTP Port:
80
Telnet Port: 23
1. Connect an RS-232 cable from the PC to the 8x8 DVI DL Matrix with Push
Button Controls .
2. Launch a terminal emulation program (e.g. HyperTerminal) and use the
following settings:
Baud Rate: 19200
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
3. Set the IP address for the matrix using the
#sipadd
command (see page
46 for details).
4. Set the subnet mask using the #snetmask command (see page 47 for
details).
5. Set the gateway (router) IP address using the #sgateway command
(see page 44 for details).
6. Set the Telnet listening port using the
#set_telnet_port
command
(see page 43 for details).
7. Set the HTTP listening port using the #set_http_port command
(see page 42 for details).
8. Power-cycle the matrix to reboot and complete all IP setting changes.
9. Type the IP address that was specified in step 3, in a web browser to access
the Web GUI or use the same IP address to Telnet to the matrix.
NOTE: Depending upon the network, the IP address, subnet mask,
gateway IP, Telnet port, and HTTP port will need to be set. Consult
your network administrator to obtain the proper settings.