Page 10 Edition I
03.12.2012
6.2.
Overview of temperature settings
Preview of a specific temperature is signalled in the first segment of the display. Individual
lines are illuminated on the display, to indicate the type of temperature shown – returning to the
boiler, flowing from the boiler, and DHW temperature. See figure below:
- Overview of temperature of water flowing from the boiler
- Overview of DHW temperature
- Overview of temperature of water returning to the boiler
6.3.
Manual mode – connected devices.
Pressing the button
switches from automatic mode to manual mode. The controller
immediately stops the boiler and the pump. In this mode, the user can start and stop the electrode
boiler, DHW pump and CH pump, manually and independently of each other. To do so, follow the
steps below:
On pressing button
the display shows the temperature of the water returning to
the boiler. It is also possible to see the temperature of the water flowing from the boiler.
Previewing DHW temperature is possible, providing additional hot water pumping is
activated (
⇒
Service Parameters p.13).
Viewing all temperatures is possible both in automatic and manual modes. To switch the
temperature shown on the screen, press the button
on the panel. Press the button again
to view the next temperature.
Controller operating in manual mode
and
and
and
Electrode boiler
Green LED is lit at the bottom
of button
.
Pressing the button switches
off the boiler and extinguishes
the light
CH pump
Green LED is lit at the bottom
of the button
.
Pressing the button switches
off the pump and extinguishes
the light
DHW pump
Green LED is lit at the bottom
of button
.
Pressing the button switches
off the pump and extinguishes
the light