Geco G-913-P01, Руководство по эксплуатации и обслуживанию

Страница: 8 / 12

USER MANUAL G-913-P01 PAGE 8
PPUH „GECO” Sp. z o.o. ISSUE I AS OF 2018.09.13
8.2 Reading of registered measurements
At any time during the device operation, it is possible to read the data registered on it. There are
two ways to read.
1) Reading of recorded data without using a configuration file
After plugin USB memory in without a configuration file on it you will save on this USB memory
device 30 000 last registered measurements.
File *.txt with saved data is located in
G913_xxx folder and the file name is R_rrmmdd.txt
Where:
xxx – Recorder ID
rr – year of reading
mm – month of reading
dd – day of reading
2) Reading of recorded data with using a configuration file (see Fig 3.)
After plugin USB memory in with a configuration file on it named „READ.txt”, registers
could be saved in ways shown below:

Reading a certain number of registers (from 1 to 30,000)
In the file " READ.txt ", write R: XXXXX
where XXXXX is any number between 1 and 30,000 corresponding to the number of read
entries

Reading from 1 to 24 hours
The file " READ.txt " should be written H: XX
where XX is any number from 1 to 24 corresponding to the number of hours to be read

Reading form 1 to 90 days
The file " READ.txt " should be written D: XX
where XX is any number from 1 to 90 corresponding to the number of days to be read

Reading from 1 to 3 month
The file " READ.txt " should be written M: X
where X is any number from 1 to 3 corresponding to the number of month to be read
Warning!!!
Entering an incorrect number or omitting the configuration variable "R:", "D:", "H:", "M:"
will skip this file and read the maximum number (30,000) measurements and save the file
REPORT.txt in which the information will be attached additional.