Gecko in.ye, Техническое руководство, Страница: 32 / 57

31
Up/Down key
Use
the
Up /
Down
keys
to set desired water
temperature The
temperature setting will
be displayed for 5 seconds
to confirm your new
selection
When the Set Point
indicator is lit the
display shows the
desired temperature,
NOT the current water
temperature!
98
Programming the system
Depending on system
configuration the system
performs either purge
cycles or filter cycles
Filter cycles
To program the filter
cycles, you must enter the
duration and frequency
During a filter cycle,
pumps & blower run
at high speed for one
minute to purge the
plumbing Pump 1 or CP
then runs at low speed for
the remainder of
the cycle
Setting filter cycle duration
Press and hold
the Prog
or
Light
key until the display
shows
d xx
, with "
xx
"
representing the duration
in hours
Use the Up / Down keys to
change setting
0 = no filtration
24 = continuous filtration
Note: it's not recommended
to set this to "0".
Off Mode
This mode allows you
to stop all outputs for
30 minutes to perform a
quick spa maintenance
Press and hold
Key 1
for
5 sec to activate the
Off mode Press
Key 1
to reactivate the system
before the expiration of
the 30 minute delay
While the Off mode is
engaged, the display will
toggle between OFF and
the water temperature
Purge cycles
To program the purge
cycles, you must select
the frequency During a
purge cycle, all pumps
and the blower run for
one minute
Purge cycle frequency
Press and hold the Light
key until the display shows
Fx, with "x" representing
the number of purge
cycles per day (up to 4)
Use
the
Up /
Down
keys
to change setting
When the desired setting
is displayed, Press the
L ight key to confirm
A purge cycle will start
immediately
The Filter indicator lights
up when a purge cycle
is on
F 2
Setting the temperature
display units
Press the Light key again
The display will show
either
°F
or
°C
Use the Up / Down keys
to change units
Press
the L
ight key a last
time to go back to normal
mode
°F = Fahrenheit
°C = Celsius
Filter cycle frequency
Press the Prog or Light
key again The display
will show Fx , with " x "
representing the number
of filter cycles per day (up
to 4)
Use the Up/Down keys
to change the setting
When the desired setting
is displayed, Press the
Light key to confirm
A filter cycle will start
immediately
The Filter indicator lights
up when a filter cycle is on
F 2
Keypad overview