GeChic On-Lap M505E, Руководство пользователя

Страница: 15 / 40

9
Section 7 Installation of VESA 100 Arm or Wall Mount
Please follow the steps below for setup.
○
1
Screw the M505 VESA 100 Bracket (Optional) to the I/O base
of the monitor by 4 M4 screws.
○
2
Clip the monitor screen and VESA 100 aluminum alloy bracket
together by the two clips to prevent the screen from falling down.
○
3
Screw M505 VESA 100 bracket onto a monitor arm or wall mount
by 4 M4 screws.
Chapter 3 Hot Keys, LED and OSD Menu Instructions
Section 1 Hot Keys & LED Indications
Do not press any two shortcut keys at the same time, otherwise the buttons may
not respond or react incorrectly.
1. LED Light Description
It shows green light when On - Lap Monitor turns on and shows red light when it
stands by. There is no light when the monitor is off.
2. Hot Keys Description
Power Press Power Button to power on/off the Monitor.
Input Source/Exit
Press this button to show "Input Source" and then press
to switch the input sources. When using the OSD menu,
press this button to return to previous page.
Menu/Select
Press this button to launch OSD panel. When using OSD
menu, press this button to select and enter the next page.
Increase Volume/
Next
Press this button to show "Volume bar". Press and hold this
button to increase the volume continuously. In the OSD
menu, press this button to move down or to the right.
Decrease Volume/
Previous
Press this button to show "Volume bar". Press and hold this
button to decrease the volume continuously. In the OSD
menu, press this button to move up or to the left.
+ Reset
Press both "Exit" and "Decrease Volume/Previous" at the
same time and OSD will be reset as the factory settings.