Operation
S er vi ce
4
Which thermal paper should be used ?
The printer mechanism is specified for a paper width of 82 mm +/- 0.5, with a weight of
60 g/sqm. Other paper widths may cause dysfunctions. GeBE offers paper rolls with a
42 mm diameter (app.25m) and a weight of 60g/sqm in its standard program . Other
diameters are available on request. For special applications, archivally safe, two-ply,
or water, grease, or alcohol resistant papers are available.
The GeBE team will gladly assist you in selecting a suitable thermal paper.
Which side of the thermal paper can be printed on ?
The printable side of the paper roll is always the side facing out. When in doubt, test
the paper with a fingernail: The thermosensitive side will blacken, when you run your
sharp fingernail over the paper applying pressure.
How is the paper roll inserted?
For easy service, unlock the front lid, and remove the printer cassette from the metal
housing. Then, pull out the rewinder disk on the side, and remove the remaining paper.
Unlock the paper roll axle on both sides, before pulling it out of the paper roll holder to-
ward the top (Avoid wiggling, since it might cause damage to the paper roll holder).
Push the paper roll axle inside the new paper roll, and insert it in the paper roll holder. -
Guide the paper around the rubber roll, below the cassette housing and back to the pa-
per rewinder. Push the printer mechanism cassette back into the housing until the
catch locks in place.
G e B E E +F G m b H • w w w . o e m - p r i n te r . c o m • G e B E D o c . N o . S M A N - E - 487 - V 1. 1 • G P T - 444 3 • P ag e 4/ 12
