Installation
5
4 Installation
4.1 Installation in a front panel
The plastic housing of the GPT-4352 printer can be in-
stalled with two screws in an easily done cut-out of a
front panel with up to 4 mm thickness. The contact sur-
face is flat. The edge of the housing juts out by 1 mm,
covering the space between the panel and the housing.
The housing is pushed into the cut-out from the outside,
and then easily screwed on.
The two holes of 2.8 mm diameter allow the use of
M2.5 screws.
4.2 Partial installation in plastic casing
As shown in the picture, the printer housing can also be
installed at the edge of a casing. This installation variant
has the part of the printer housing that contains the pa-
per roll extending beyond the unit casing. This saves
room in the device casing for the installation of other
components.
To facilitate installation in different casing shapes, the
outer wall of the paper storage was left smooth below
the bearing collar. The housing can project about 19 mm
from the casing edge, since about half of the paper sto-
rage can be used, right up to the slanting slot for inser-
ting the mounting plate.
4.3 Example for installation and application
As the pictures show, the installation types are almost
unlimited. The advantage of the compact thermal printer
Mini Mulde in its plastic housing consists above all of
the fact that it becomes possible to use the practical Ea-
syloading technology of the printer mechanisms also in
applications with smaller numbers of items.
For this small GeBE-printer a paper rewinder is
available, so that also a printer with presentation stage,
like shown above, can be used e.g. in a control panel
housing. The Mini MULDE is used also in the Desktop
Printer Series POCKET and is suitable for Handheld
computers with printing station.
Application in a pocket printer with infrared interface.
GeBE E + F GmbH • www.oem-printer.com • GeBE Dok.Nr.: SMAN-E-413-V4.1 Easy-Loading Thermal Printer GPT-4352(-60)
