1 3
Ge BE E + F Gm bH • ww w .oe m- pri nte r .co m • Ge BE Do k.N r .: SM AN -E- 413 -V4 .0 Eas y-L oad ing The rm al Pri nte r GPT -43 52( -60 )
O pe ra tio n
8 O pe ra tio n
8.1 Which thermal paper is suitable ?
The printer is specified for a paper width of 57.5 ± 0.5 mm, with a weight
of 60 g/sqm. GeBE is of fering suitable paper r olls (GPR-T01-058-031-007-
060A r esp. GPR-T01-058-060-007-0 60A for GPT -4352-60) as part of the
standar d pr ogram. Other papers may not be suitable for use.
Thermal papers that ar e r esistant against water , gr ease, or alcohol ar e
available for special applications. W e will gladly assist you in your selec-
tion of the suitable thermal paper .
How do I insert the paper?
Use paper r olls that ar e coated on the outside with a width of 57.5 mm ±
0,5mm and a winding diameter of 31 mm and 60 mm for GPT -4352-60.
Standar d GPT -4352:
GPR-T01-058-031-007-0 60A
Standar d GPT -4352-60: GPR-T01-058-060-007-0 60A
1.
Unwind about10 cm (4 ") of paper fr om the r oll. Keep the layers wound
tightly .
2.
Open the printer cover by slightly pr essing the LEVER in the cover up-
war ds. The print r oll is lifted fr om the mechanism together with the cover .
The cover is now easy to open.
3.
Insert the paper r oll in the paper storage, so the outside shows towar d
the printer mechanism. Only this outside can be printed on.
4.
Close the cover by applying str ong pr essur e. Y ou can hear it snap shut.
Now you can rip of f paper at the tear bar without the cover opening up or
the paper sliding thr ough the print head.
1.
2.
3.
4.
8.2 Maintenance, Cleaning
After lar ger print ef forts, depending on the paper quality and adverse en-
vir onmental conditions, it may be necessary to clean the print head, sen-
sor , and the platen r oll, especially , if some ar eas ar e no longer printed
pr operly .
• Open paper supply lid and r emove paper r oll.
• Loosen dirt particles at the paper sensor and the tear -of f bar with a
small brush.
• Blow for cefully into the paper supply compartment in or der to r emove
the coarse dust.
• Soak Q-tip in isopr opanol (IP A) and clean the print head, or use print
head cleaning pin/cleaning car d.
• Other stubbor n debris can also be r emoved with a Q-tip (IP A).
Never use sharp objects for cleaning. This might cause da-
mage to the print head.
Which side of the thermal paper can be printed on?
On the paper r oll, the side to print on is, in almost all cases, the
outside. If you should have any doubts, just do the finger nail
test: Quickly drive the edge of a finger nail with slight pr essur e
over the paper . The thermosensitive side will tur n black as a r e-
sult of the frictional heat.
