GeBe 570817, Руководство пользователя

Страница: 30 / 36

30
English
FUELFILTER
1. . Remove the screws (1),
the cover (2) and Oil
observation window (3).
2. Drain the fuel in the fuel
tank(4). Hold the tube clip
(7) toward downward and
pull out the fuel tube (8)
which connect on the fuel
tank, then disassemble fuel
filter
3. Put the fuel filter into
noncombustible or higher
flash point solvent and
clean it.
4. Assemble fuel filter to
the main jet (5) on the fuel
tank. Then assemble fuel
tube to main jet on the fuel
tank and install tube clip.
STORAGE
Long term storage of your machine will require some
preventive procedures to guard against deterioration:
DRAIN THE FUEL
1. Turn the 3 in 1 switch to “OFF” (1).
2. Remove the fuel tank cap, remove the filter.
Extract the fuel from the fuel tank into an approved
gasoline container using a commercially available
hand siphon. Then, install the parts.
3. Start the engine and leave it running until it stops.
The engine will stop in approx. 20 mins.
TIP: Do not connect with any electrical devices.
(Unloaded operation). Duration of the running engine
depends on the amount of the fuel left in the tank.
Fuel is highly flammable and poisonous. Check
“SAFETY INFORMATION”. Immediately wipe off
spilled fuel with a clean, dry, soft cloth, since fuel
may deteriorate painted surfaces or plastic parts
4. Remove the screws, and remove the cover
5. Drain the fuel from the carburetor by loosening
the drain screw on the carburetor float chamber.
6. Turn the 3 in 1 switch to “OFF”.
7. Tighten the drain screw.
8. Install the cover and tighten the screws.
9. Turn the fuel tank cap air vent knob to “OFF” after
the engine has completely cooled down.
ENGINE
Perform the following steps to protect the cylinder,
piston ring, etc. from corrosion.
1. Remove the spark plug; pour about one table-
spoon of SAE 10W-30 into the spark plug hole and
reinstall the spark plug.
2. Recoil start the engine by turning over several
times (with 3 in 1 switch knob off) to coat the
cylinder walls with oil.
3. Pull the recoil starter until you feel compression.
(This prevents the cylinder and valves from rusting).
4. Then stop pulling.
5. Clean the outside of engine and spay antirust
additive.
6.Store the generator in a dry, well-ventilated place,
with the cover placed over it.
7. Lay the engine vertically.