PLEASE READ INSTRUCTIONS
CAREFULLY BEFORE OPERATING
EQUIPMENT
• The tester uses 9V battery for power supply.
• Please use battery specified; otherwise it may result in
damages to the equipment.
• Keep equipment away from dust, debris, humidity and
temperature over 104˚F (40˚C).
• Never dismount equipment arbitrarily.
• Maintenance and care of equipment to be conducted by a
professional personnel is recommended.
• The tester will power down automatically if inactive for 30
minutes.
• Please take out batteries if equipment is unused for a long
period of time to prevent battery liquid from leaking and
corrosion.
• Never use the equipment to detect power cord with
electricity (such as power supply circuit of 220V), other
wise, it may result in damages to the equipment and/or
personal injury.
• Never conduct testing in thunderstorms to prevent
lightning strike and impact which can jeopardize personal
safety.
10
Unit: is used to select length unit M (Meter) and Ft (Feet).
Calibration: is used for calibrating.
Quit: is used to return to the main menu.
Calibration and Setup Function
Entering the calibration and setup function, the tester will display
as follows:
Dynamic Calibration Function
For accurate measurement of cable length, the calibration oper-
ation process should be as follows:
Insert same type of cable for given length into Main Tester, do
not insert into far-end remote identifier, push key (Yes) to un-
dertake measurement and display the measured length:
Hold and (- / +) to adjust the length to actual length and
then push to save calibration setting. If cable length is
too short (<10M) display is as follows.
Pair&L