Do not operate the radiant surface units if
the glass is broken.
or cleaning
solution may penetrate a broken cooktop and
create a risk of electrical shock. Contact a
qualified technician immediately should your
glass cooktop become broken.
. Avoid scratching the glass cooktop surface with
sharp implements, or with rings or other jewelry.
. Never use the glass cooktop surface as
a cutting board.
not place or store items on top of the glass
cooktop surface when it is not in use.
●
Do not place any spoons or other stirring
utensils on glass cooktop surface when is in
use.
They may become hot and could cause burns.
●
Only certain types of glass, glass/ceramic,
earthenware or other glazed containers are
suitable for surface cooking; others may break
because of the sudden change in temperature.
To minimize the possibility of burns, ignition of
flammable materials, and spillage, the handle of a
container should be turned toward the center of the
range without extending over nearby surface units.
●
Never try to clean the cooktop surface when it
is hot. Some cleaners produce noxious fumes and
wet cloths could cause steam burns if used on a
hot surface.
Always turn the surface unit control knob
to OFF before removing cookware.
Keep an eye on foods being fried HI or
MEDIUM HIGH heat settings.
●
When flaming foods are under the hood, turn the
fan off.
The fan, if operating, may spread the flame.
Foods for frying should be as dry as possible.
Frost on frozen foods or moisture on fresh foods
can cause hot fat to bubble up and over sides of pan.
●
Use little fat for effective shallow or deep-fat
frying. Filling the pan too full of fat can cause
when food is added.
If a combination of oils or fats will be used in
frying, stir together before heating, or as fats
melt slowly.
.
fat
slowly,
and watch as it heats.
.
a
fat thermometer whenever
possible to prevent overheating fat beyond the
smoking point.
. Never try to move a pan of hot fat,
a
deep fat fryer. Wait until the fat is cool.
SAVE THESE
INSTRUCTIONS
INSTALLING YOUR RANGE
Your range,
many other household
heavy and can settle into soft floor coverings such as
cushioned vinyl or carpeting. When moving the
range on this type of flooring, use care, and it is
recommended that these simple and inexpensive
instructions be followed. Please check your range to
ensure all packaging materials and protective tape
covering are removed from areas, such as the door
trim, main top frame, end caps, etc., before using.
The range should be installed on a l/4-inch-thick sheet
of plywood (or similar material) as follows: When the
covering ends at the front of the range, the area
that the range will rest on should be built up with
plywood to the same level or higher than the floor
covering. This will allow the range to be moved for
cleaning or servicing. For complete information, see
the Installation Instructions.
Leveling the Range
Leveling screws are located on each
To remove drawer, pull the drawer
corner of the base of the range.
out all the way,
up the front and
Remove the bottom drawer and you
take it out. To replace drawer, insert
can level the range on an uneven
glides at back of drawer beyond
floor
the use of a nutdriver.
stop on range glides. Lift drawer
if necessary to insert easily. Let
front of drawer down, then push
in to close.
One of the rear leveling
screws
engage the-Anti-Tip
device (allow for some side to
side adjustment). Allow a minimum
clearance of
between the range
and the leveling screw that is to be
installed into the Anti-Tip device.
5
