12
Consumer Support
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
Window Installation Instructions.
Install the Support Brackets
Thread a bolt into each support bracket.
Position the brackets on the case bottom so they
will be near the outermost point on the window
sill. (Brackets may be positioned in either
direction, for maximum support, depending on
the depth of the window sill.) Attach a support
bracket to each side of the case bottom using
two 3/8
″
slotted washer head screws on each side.
The case should be slightly tilted to the outside.
Use a level; about a 1/2 bubble will be the correct
case slant to the outside.
5
Measure and Cut the Window Filler Panels
6
Measure the distance “X” between the face of
the window molding and the side of the case.
Measure both sides of the case separately.
Subtract 3/16
″
(one groove) from “X” to
determine the required width you need to
cut the filler panels.
Using a sharp knife, mark the groove until
the filler panel becomes weak enough to
break apart.
C
B
A
Window molding
Bolt
3/8
″
screws
Support bracket
“X”
Window sill
