16
Installation
Stainless Steel Interior Dishwashers
• Carefully upright the dishwasher.
Important:
The weight of the door panel may
cause the door to fall heavily. The correct
spring tension will prevent the door from
falling too heavily or raising by itself from a
fully open position.
• Hold the door and open fully. If the door
falls too heavily, or if the door starts to close
by itself, the spring tension will need to be
adjusted.
If adjustment is required:
• To locate the spring adjustment slots,
carefully lay the dishwasher on its back.
• Remove the 3 screws holding the base plate
to the bottom of the dishwasher.
• Locate the spring tension slots on the sides.
• With a pair of pliers, pull the spring clip out
and down to the next slot for more tension,
or up to the next slot for less tension.
• Upright the dishwasher and test door
balance. Continue this procedure until the
door is balanced.
• Reinstall the base plate with screws.
4
Step
Adjust
The Door
Balance
Remove 3 Screws
Spring
Clip
Install
and
Adjust
4 Legs
Lock
Washer
Nut
Leveling
Leg
Locate the 4 leveling legs, 4 nuts and 4
locking washers.
• Install a nut followed by a lock washer onto
each leveling leg.
• Insert the leveling leg into the bottom of the
dishwasher. Screw the leg in until the total
dishwasher height nearly matches cutout
height.
• Screw the nut up against the bottom of the
dishwasher, do not tighten until final
installation is completed.
If the plastic chassis cover has not been
removed, do so at this time. See page 13,
“Remove plastic chassis cover.”
5
Step
Install
Leveling Legs
Содержание ZBD4600XBB
Страница 22: ...22 Notes Stainless Steel Interior Dishwashers ...