GE ZBD4600XBB, Руководство по установке

Страница: 14 / 24

3/4" Custom Panels
Models ZBD4800X Dishwashers
14
• Lay the custom panel on a flat surface with
the appearance side down. Locate the
vertical center of the panel at the top. Use a
carpenters square to draw a center line from
top to bottom on the panel.
Use the template supplied to find the location
of the support brackets which hold the custom
panel to the front of the dishwasher door.
• Check to be sure the spacer bar below the
control panel is set to the desired location.
• Measure the total height of the control
panel. See illustration on page 12.
• Find and mark that location on the graded
rule on both top corners of the template.
3
A
Step
(continued)
Secure
Custom
Panel to
Dishwasher
115
125
135
145
155
MM INCHES CONTROL PANEL HEIGHT
4-3/4
5
5-1/4
5-1/2
• Place the template on the panel with the
large “V” notch at the top and small “V”
notch at bottom. Align the template center
line to the center line drawn on the panel.
Align the top of the template with dimen-
sions previously marked on the graded rules.
The windows on both sides of the template
will help you align the template to the panel
accurately.
• Tape the template in place and use an awl to
mark screw hole locations indicated.
• Remove the template and drill pilot holes
3/32" deep in the marked locations.
• Secure all brackets to the custom panel using
Screws (B) provided.
Screw B