GE T2100, Руководство по обслуживанию

Страница: 91 / 152

Revision A GE T2100 Treadmill 6-19
2021403-031
Troubleshooting: TDU Troubleshooting Tables and Status LEDs
0x05 Fatal
(Halts
Current
Operation)
Communication Error:
!
<01> Could not check for drive
errors.
!
<02> Could not check for drive
axis errors.
!
<03> Could not read the belt
speed from the drive.
!
<11> Invalid error bit pattern
while checking for drive errors.
!
<12> Invalid error bit pattern
while checking for drive axis
errors.
!
<13> Invalid speed detected
while reading belt speed from
drive.
!
<255> Command not received
from host within 4 seconds
while the belt was enabled.
Communication error between the processor board and the drive
controller, or the processor board and the host.
1. Powercycle the GE T2100 Treadmill and monitor the GE T2100
Treadmill for reoccurrence of this error. (This may be an isolated
incident.)
2. Check for loose wiring and connections between the drive
controller and the e-box.
3. Check for loose wiring and connections between the treadmill
and the host.
4. Check the terminal connections on the X1 connector on the
drive controller. See “Drive Controller X1 PIN descriptions” on
page 7-22.
5. Check the power board and processor board test points and
verify they are operating within the test range. See “Power
Supply Voltage Checks and Fuses” on page 6-27.
6. Replace the drive controller with a known working drive
controller. (If the problem persists...)
7. Replace the processor board. See “PCBs and Power Supply
Replacement” on page 7-28.
0x06 Fatal
(Halts
Current
Operation)
Over-voltage Measures power into the GE T2100 Treadmill.
1. Powercycle the GE T2100 Treadmill and monitor the GE T2100
Treadmill for reoccurrence of this error. (This may be an isolated
incident.)
2. Check the fuses. See “Power Board Fuse Locations” on page 6-
29.
3. Check the power board and processor board test points and
verify they are operating within the test range. See “Power
Supply Voltage Checks and Fuses” on page 6-27.
4. Replace the power board. See “PCBs and Power Supply
Replacement” on page 7-28.
0x07 Fatal
(Halts
Current
Operation)
Under-voltage:
!
<00> Under-voltage detected
while system still operating.
!
<255> Under-voltage caused
system to shut down while the
belt was enabled, or while the
elevation motor was active.
Measures power into the GE T2100 Treadmill.
1. Powercycle the GE T2100 Treadmill and monitor the GE T2100
Treadmill for reoccurrence of this error. (This error logs each
time the treadmill is powered off. This may be an isolated
incident.)
2. Check the fuses. See “Power Board Fuse Locations” on page 6-
29.
3. Check the power board and processor board test points and
verify they are operating within the test range. See “Power
Supply Voltage Checks and Fuses” on page 6-27.
4. Monitor AC power into the GE T2100 Treadmill. Watch for
inadequate power supply.
5. Replace the power board. See “PCBs and Power Supply
Replacement” on page 7-28. (If the problem persists...)
6. Replace the processor board. See “PCBs and Power Supply
Replacement” on page 7-28.
0x08 Warning Belt Start Not an error. Indicates the belt was started at this time.
TDU Event /
Error Code
Status
Definition and Detail
Description
Check These Items