Instillation Requirements
(continued)
IMPORTANT. . . Please Read Carefully.
Use of adapter plug
Because of potential safety
hazards under certain conditions,
we strongly recommend against
use of an adapter plug. However, if
you still elect to use an adapter,
where
codes permit, a
TEMPORARY
may
be made to a properly grounded
two-prong
outlet by use of a
listed adapter (Fig. 2) available
at most
hardware stores.
TE
MP
OR
ARY
METHOD
PLUGS NOT
PERMITTED
CA NADAI
ALIGN LARGE PRONGS
““
AND FIRM CONNECTION
Fig. 2
USE
The
in the adapter must
be aligned with the larger
in
the wall outlet to provide proper
polarity in the connection of the
power cord.
CAUTION: Attaching adapter
ground terminal to
cover
screw does not ground the appliance
unless cover screw is metal, and
not insulated, and wall outlet is
grounded through house wiring.
You should have the circuit checked
by a qualified electrician to make
sure the outlet is properly
grounded.
When disconnecting the power
cord from the adapter, always
hold the adapter with one hand.
this is not done, the adapter ground
terminal is very likely to break with
repeated use.
Should the adapter ground
terminal break, DO
USE the
appliance until a proper ground
has again been established.
Use of
cords
Because of potential safety hazards
under certain conditions, we
strongly recommend against the
use of an extension cord. However,
if you still elect to use an extension
cord, it is absolutely necessary that
it be a
listed 3-wire grounding
type appliance extension cord
having a grounding type
and
outlet and that the electrical rating
of the cord be 15 amperes (minimum)
and 120 volts. Such extension cords
are obtainable through your
service organization.
The refrigerator should
always be plugged into its own
individual
(115 volt, 60 Hertz, single phase
AC). This is recommended for best
performance and to prevent
overloading house wiring circuits,
which could cause a possible
hazard from overheating wires.
Refrigerator Instigation
This refrigerator is designed for
free-standing installation only. It
should not be recessed or built-in.
Install the refrigerator on a base
strong enough to support a fully
refrigerator. If the base is
not level, adjust the feet of the
refrigerator.
If the refrigerator is in a
or
colder room, it will operate but
it will not
properly.
Also see Energy-Saving Tips
regarding location.
Clearance
the following clearances
for proper air circulation:
Top,
Back, 5“
Sides, 1/2”
Operating Your
Refrigerator
Temperature
Control Dial
The temperature control dial has
settings from “MIN” to “MAX”
●
I
“MIN” is the warmest.
“MAX” is the coldest.
Initially set the temperature
control
at the midpoint.
After using the refrigerator for
24 hours, adjust the temperature
control to the setting that is best
suited to your needs.
Note:
If this refrigerator is unplugged
or turned off, you must
3
minutes before restarting it or
plugging it back in. If you attempt
to restart it in less than 3 minutes, it
will not start.
Note:
Turning temperature control
to
stops cooling but does
shut
power to the refrigerator.
