GE Solar 7000, Руководство по обслуживанию

Страница: 164 / 214

CONFIGURATION: Advanced User Procedures
6-12 Solar 7000/8000/View Patient Monitor Revision J
414993-001
Programming Time
and Date Change the time when the system is switched to or from daylight savings
time or when absolutely necessary.
NOTE: When a monitor is first connected to the Unity Network, the
time and date is automatically updated from the network time.
WARNING
Changing the time or date settings may result in the loss
of patient data history. If one monitor’s time or date is
changed, all monitors on the network will ‘listen’ and
follow suit within 3-5 seconds. Changing the time base of
one monitor may cause some loss of patient data history
for all the monitors on the network.
There are two ways to change the time and date; the SERVICE MODE
menu method is preferred.
The following procedure explains how to use the TIME AND DATE
option in the monitor SERVICE MODE menu or the SET CLOCK option
in the BOOT LOADER service menu.
From BOOT LOADER 1. To activate BOOT LOADER program, doing the following:
◆
Hold down the NBP GO/STOP and ZERO ALL keys on the
front panel. (For the Solar View remote display controller,
hold down the two blank keys.)
◆
Press and release the Trim Knob control.
◆
Keep holding the NBP GO/STOP and ZERO ALL keys (or two
blank keys for the SolarView remote display controller) until
the BOOT LOADER menu appears on the display.
2. Dial the Trim Knob control to access the SET CLOCK option from the
SERVICE MENU. Press the Trim Knob control to change and select
the correct time and date.
From SERVICE MODE
Menu 1. To access the TIME AND DATE menu, execute the following menu
sequence, starting from the MAIN menu:
CUSTOMIZE MONITOR or MONITOR SETUP
SERVICE MODE
Password
Enter day and month from monitor screen with leading zeros.
(July 4 = 0407)
TIME AND DATE
Set Time
2. The time is displayed as a 24-hour military clock. A popup menu is
displayed and the hour is highlighted. To set the time, select SET
DATE option and use the Trim Knob control.
Set Date
3. To set the date, select SET DATE option from the time and date
menu. A popup menu is displayed. Use the Trim knob control to
select the date.