11
FOR 3
1
⁄
4
″
X 10
″
RECTANGULAR
DUCTED DISCHARGE
INSTALLATIONS ONLY:
Attach
exhaust adaptor/damper
over the appropriate
knockout opening (for vertical or horizontal,
depending on installation) with two exhaust adaptor
screws. Make sure damper
pivot
is nearest to
top/back
edge
of hood. Remove
tape
from damper flap.
Up to 1
″
side-to-
side adjustment
Tape
Top/back edge
Exhaust adaptor/damper
(vertical discharge position)
Pivot
(depending on
installation)
FOR 7
″
ROUND VERTICAL
DUCTED DISCHARGE
INSTALLATIONS ONLY:
Bend up the duct alignment ears in preparation for
later attachment of the 7
″
duct.
8
9
Installation Instructions
NOTE:
The exhaust adaptor/damper can be installed
up to 1 inch on either side of the hood center to
accommodate off-center ductwork. In extreme off-
center installations, one end of the duct connector may
need to be trimmed to clear the electrical cable clamp.
Exhaust adaptor/damper
(horizontal discharge position)
Attachment ear tabs
FOR RECESSED-BOTTOM
CABINETS ONLY
10
Wood shims
(minimum thickness
3/8
″)
•
If the cabinets have front, side or back trim, make
2 wood shims a minimum of 3/8
″
thick and cut to
fit the width of the inner recessed cabinet bottom.
Attach them to the cabinet bottom recess on both
sides. See Step 11 for marking locations.