GE PVUS930, Руководство пользователя и инструкции по установке, Страница: 13 / 42

12
‡ This product can be installed in 2 different Z ays.
- Mounting the hood in the lower part of the cabinet .
B type installation Fig.9.
- Mounting the hood on the wall:
A type installation Fig.9.
0RXQWLQJWKHKRRGLQWKHORZHUSDUWRIWKHFDELQHW)LJ%
- Chec N that the scre Z s used that are not supplied Z ith the product are suitable for the type of
object.
- Position the ¿ xing template on the lo Z er part of the shelf Fig.8B), considering the minimum
distance from the coo N er top).
- Ma N e 6 holes in the shelf respecting the measurements indicated Fig.7).
- Fix the 4 scre Z s A Z ithout tightening them completely.
- Position the hood under the pensile, push to Z ards the Z all up to end run, tighten/fasten the 4
scre Z s A and ¿ x it de ¿ nitively using the 2 safety scre Z s B .
0RXQWLQJWKHKRRGRQWKHZDOO)LJ$
Position the ¿ xing template on the Z all Fig.8A), considering the minimum distance from the
coo N er top).
- Ma N e 4 holes respecting the measurement indicated in the ¿ gures Fig.7).
- Fix the 2 upper scre Z s A Z ithout tightening them completely along Z ith the plugs.
- Hang the hood on the Z all, aligning it in a horizontal position and tighten/fasten the 2 scre Z s
A . When it has been regulated, ¿ x it de ¿ nitively using the 2 safety scre Z s B .
For the various installations use scre Z s and scre Z anchors suited to the type of Z all e.g.
reinforced concrete, plasterboard, etc.). If the scre Z s and scre Z anchors are provided Z ith the
product, chec N that they are suitable for the type of Z all on Z hich the hood is to be ¿ xed.
‡ Limited to installation on plasterboard Z alls: ma N e sure that the scre Z s are ¿ xed to the Z all
support elements. If this is not the case, install a support structure made up from 2 by 4 inch
5.08 by 10.16 cm) cross members in correspondence Z ith the scre Z anchorage points.