GE Profile PTWN8055MMS, Техническое обслуживание руководство

Страница: 35 / 46

– 35 –
( Continued Next Page )
Hall Sensor
• The Hall effect sensor measures the motor rpm.
• Four wires connect the Hall sensor to the power
board at the 6-pin dark blue connector. (See
Circuit Board Connector Locator View .
)
• If the sensor has failed, the motor will not
operate.
• The Hall sensor clips onto the frame of the
stator, and can be replaced separately.
Test Locations Resistance Voltage (DC)
Red to Blue
19K Ω
0 VDC
Blue to Brown
9K
Ω 12 VDC
Brown to Red 9K Ω 12 VDC
Hall Sensor resistance and supply voltage from
power board location BL6.
Power Board
Location BL6
3. Pull the rotor away from the drive shaft.
Note
:
Removal of the wiring guard (held in place by
one 10-mm hex-head screw) will give better access
to the motor connectors.
Rotor Nut
Bottom View
Rotor
Wiring Guard
To remove the rotor and stator:
WARNING : The rotor is not grounded. Unplug the
washer before servicing to avoid electrical shock.
1. To access the motor, the washer must be placed
on its side. Place a towel or blanket on the
fl oor to prevent scratches to the surface of the
washer.
2. Remove the 24-mm (15/16-in. SAE equivalent)
rotor nut with a socket or adjustable Crescent
wrench (rotate rotor nut counterclockwise to
remove). Remove the
fl at washer.
Note
:
Use a rubber mallet if needed to tap the
wrench to break the nut free.