49-3000295 Rev. 0
15
Care and Cleaning
C
A
R
E
A
N
D
C
L
E
A
N
IN
G
Exterior of the Washer
Immediately wipe off any spills with a damp cloth.
Certain internal parts are intentionally not grounded and may present a risk of electric shock only during servicing.
Service personnel DO NOT
contact the following parts while the appliance is energized: Drive Motor, Lid Lock,
Water Valves, Drain Pump and Recirculation Pump.
- Electrical Shock Hazard
Interior of the Washer
To clean the interior of the washer, select the
Bulky
cycle on
the control panel. This
Bulky
cycle should be performed, at
a minimum, once per month. This cycle will use more water,
in addition to bleach, to control the rate at which soils and
detergents may accumulate in your washer.
NOTE:
Read the instructions below completely before starting
the
Bulky
cycle.
1. Remove any garments or objects from the washer and
ensure the washer basket is empty.
2. Open the washer lid and pour one cup or 250 ml
of liquid bleach or other washing machine
cleaner into the basket.
3. Close the lid and select the
Bulky
cycle. Push the
Start
button.
4. When the
Bulky
cycle is working, the display will show the
estimated cycle time remaining. Do not interrupt the cycle.
IMPORTANT:
Run
Bulky
with 1 Cup (250 ml) of bleach once a month.
After the completion of a
Bulky
cycle, the interior of your
washer may have a bleach smell.
For basket cleaning option, download and refer to the SmartHQ
App.
Microphones
(PTW905 and PTW900 models only)
NOTE:
The washer control panel contains 2 sensitive
microphones. If the microphones become exposed to liquid
contaminates or if the audio ports become clogged, feature
performance could be degraded.
To clean the audio ports/microphones, immediately wipe
off any spills on or near the microphone audio ports. Next,
gently wet a small cotton swab with water. Be sure to wring
out excess water from swab so that it is only damp. Gently
insert the damp cotton swap into the audio port holes and
wipe out with a gentle spinning motion. Repeat process until
all contaminants are clear. Allow unit to dry. Drying times may
vary and can exceed 24hours in some cases.
Detergent Tank Clean-Out
(PTW905 and PTW900 models only)
NOTE:
All clothes should be removed from the washer prior to
cleaning out the detergent tank.
To empty out the tank and remove any remaining detergent
from the reservoir:
1. Press and hold both the
Smart Dispense
and
Smart Wash
buttons for three seconds.
2. The empty out routine will begin with the contents of tank,
mixed with water, being dispensed into the basket and
consequently drained from the machine at the same time.
3. The empty out routine will continue for approximately 15
minutes unless it is paused by the pressing of the
Start
button. If tank is initially full, routine may need to be run a
second time to empty detergent tank.
NOTE:
Optionally, hot water can be added to the tank to aid in
flushing out the system of any residual detergent prior to starting
or during the cleanout routine.
Microphones