– 26 –
Heat Shield
To remove the heat shield:
Remove the elements. (See
1.
Elements
.)
Lift and remove the left and right insulation
2.
spacers.
Disconnect the touch board wire harness and
3.
remove the tape that holds the harness to the
heat shield.
Lift the insulation from the wire entry in the heat
4.
shield and tuck the touch board wire harness
under the heat shield.
5. On 36-in. models, remove the fourteen 1/4-in.
hex-head screws, (5 on the front, 5 on the back,
and 2 on each side) from the outside of the
burner box. (On 30-in models, remove the 10
1/4-in. hex-head screws, (3 in the front, 3 in the
back, and 2 on each side) from the outside of
the burner box.)
Insulation Spacers
Disconnect
Rail
36-in. model shown
7. Raise the rear of the heat shield approximately 3
inches and disconnect the 2 ground wires from
the bottom of the heat shield.
6. Remove the 20 Phillips-head screws from the
top of the heat shield. (On 30-in. models, remove
the 5 Phillips-head screws from the top of the
heat shield.)
Rear view shown
36-in. model shown
36-in. model shown
8. Lift and remove the heat shield from the burner
box.
Note
The generator modules are not secured to
•
the burner box. With the heat shield removed,
generator modules can be accidentally moved
out of position. To ensure proper alignment of
the modules to the heat shield, it may be helpful
to note and mark the position of the generator
modules.
If a generator module has shifted out of position,
•
it may be helpful to drive one corner screw and
then shift the generator module as necessary to
align the other holes.
