Questions? Call 800.GE.CARES (800.432.2737)
or
Visit our Website at:
ge.com
LP Conversion
Gas Cooktop
Instructions
Read these instructions completely and carefully.
•
IMPORTANT –
Save these
instructions for local inspector’s use.
•
IMPORTANT –
Observe all
governing codes and ordinances.
•
Note to Installer –
Be sure to leave these
instructions with the Consumer.
•
Note to Consumer –
Keep these
instructions for future reference.
BEFORE YOU BEGIN
•
This cooktop is factory set for natural gas operation.
Conversion to LP operation should be performed
by a qualified technician or installer. Keep these
instructions for future reference. When converting
to LP, save the original parts for possible future re-use.
•
Product failure due to improper installation is not
covered under the GE Appliance Warranty.
PGP989
WARNING –
If you are using LP (bottled) gas, all
adjustments described in the following steps must be made
before attempting burner adjustments or use
of the cooktop.
WARNING –
This conversion kit shall be
installed by a qualified service agency in accordance
with the manufacturer’s instructions and all applicable
codes and requirements of the authority having
jurisdiction. If the information in these instructions
is not followed exactly, a fire, explosion or production of
carbon monoxide may result, causing property damage,
personal injury or loss of life. The qualified service agency
is responsible for the proper installation of this kit. The
installation is not proper and complete until the operation
of the converted appliance is checked as specified in the
manufacturer’s instructions supplied with the kit.
FOR YOUR SAFETY:
1
Adjustable wrench
9/32
″
(7 mm) Nutdriver
TOOLS YOU WILL NEED
T15 Torx driver
PART
QUANTITY
Brass orifices
4
Stick-on rating label
1
Installation instructions
1
PARTS INCLUDED WITH COOKTOP
Small, thin-blade flat screwdriver with approximately 1/8
″
blade width is needed to access the calibration screw.
49-80554
07-08 JR
Printed in the United States
