24
DISTRIBUTED DIGITAL FAULT RECORDER – INSTRUCTION MANUAL
SETTING UP COMPUTER-TO-DDFR ETHERNET COMMUNICATIONS
CHAPTER 1: GETTING STARTED
Z
When asked "Are you sure...", make sure you entered the correct IP
Address, Subnet Mask, and Default Gateway information, then click
the
Yes
button and change the IP setting in the DDFR.
The system will attempt to connect to the DDFR using the new IP Address.
Z
When the "Can’t connect..." window appears, click
OK
.
The warning window will disappear, leaving the DDFR IP
Configuration window, as shown at the bottom right of the above
image.
Z
Click the
Cancel
button.
Go back to the Internet Protocol (TCP/IP) window as follows:
Z
Select
Control Panel > Network and Dial-up Connections.
Z
Select
Local Area Connection
.
Z
Select
Protocol
.
Z
Select
Internet Protocol > TCP/IP
, then press
Properties
.
Z
Restore your original (computer) IP configuration.
In the example above, dynamic (automatic) IP address assignment
is used. If your IP Address is static, click on the "
Use the following
IP address
" radio button and mnually input your original
configuration, which you noted down at the beginning.
Z
Click
OK
.
You now have to delete the DDFR from the Setup screen, and "rediscover" it with its new IP
Address:
Содержание Multilin DDFR
Страница 3: ......
Страница 4: ......
Страница 8: ...TOC IV DISTRIBUTED DIGITAL FAULT RECORDER INSTRUCTION MANUAL TABLE OF CONTENTS ...
Страница 54: ...46 DISTRIBUTED DIGITAL FAULT RECORDER INSTRUCTION MANUAL SPECIFICATIONS CHAPTER 2 PRODUCT DESCRIPTION ...
