18
ALTERNATE METHOD
Surface Mounted Lamp Installation
Step 1:
Locate the center 46” ceiling panel.
From underneath, push a 6” length
of 3/8” OD plastic tubing through the
star grommet. Insert the leads of the
lamp assembly into the tubing far
enough to clear the top of the panel.
Withdraw the tubing.
NOTE:
The plastic tubing will help
guide the leads through the
grommet without damaging the
terminals.
Step 2:
Position the lamp over the hole in the
ceiling panel and drill a pilot hole for
one of the mounting screws. Install
the mounting screw and tighten
snugly. Repeat for the other
two screws.
Step 3:
Connect the light connectors to the
wiring harness, making sure the click
into place. Install the lens cover.
Step 4:
Repeat steps 1 – 3 for the other four
lamps.
Step 5:
Secure the transformer to the top of
the ceiling panel using two of the
short mounting screws included with
the lamp kit.
Step 6:
Push wire connectors into the holes
so they will not be exposed. Secure
the wires and wiring harness to the
top of the panel with tape.
Plug the lamps into the receptacle
above the door.
3/8” plastic
tubing
Star grommet
INSTALLATION INSTRUCTIONS
INSTALL HALOGEN CEILING LAMPS
Light
Light
wiring
harness
Transformer
Leads from light
Screws
Lens Cover
