PREFERRED METHOD
Recessed Installation
The ceiling lamps can be recessed or
surface mounted. The recessed installation
is preferred.
Step 1:
Locate the center 46” ceiling panel.
At each grommet location, use a
2-1/8” dia. hole saw to cut a 1” min.
deep hole through the inside skin and
into the foam insulation of the panel.
Use a 4” length of 1” dowel* as a pilot
to keep the saw from drifting. Clean
out the foam to provide clearance for
the lamp housing.
* INSTALLATION TIP
Some panels may have holes smaller
than 1” in diameter. If so, use a 3/4”
dowel and wrap it with tape to build
up to the needed size
Step 2:
Push a 6” length of 3/8” OD plastic
tubing through the star grommet.
Insert the leads of the lamp
assembly into the tubing far enough
to clear the top of the panel.
Withdraw the tubing.
NOTE:
The plastic tubing will help
guide the leads through the grommet
without damaging the terminals.
Step 3:
Push the lamp housing into the
recess and secure with the supplied
screws. Install the lens cover. Refer
to the instructions included with
the lamp assembly.
Step 4:
Mate the connectors from the parts
bag with the connectors on the
wiring harness and insert the lead
terminals into the connector until
you feel the click. Gently tug on the
wire to ensure they are connected
securely.
Step 5:
Secure the transformer to the top of
the ceiling panel using two of the
short mounting screws included with
the lamp kit.
Step 6:
Push wire connectors into the holes
so they will not be exposed. Secure
the wires and wiring harness to the
top of the panel with tape.
INSTALL HALOGEN CEILING LAMPS
17
2-1/8”
1” min.
Light
3/8” plastic
tubing
Star grommet
Leads from light
Screws
Light
wiring
harness
Transformer
