GE Monogram ZBD3500, Инструкция по использованию и уходу

Страница: 20 / 28

PROBLEM POSSIBLE CAUSE
CONTROL PANEL Time too long between touching of selected pads. Each pad must be touched within
LIGHTS GO OFF 30 seconds of the others. To relight, touch any pad again, or unlock and relatch door.
WHEN YOU’RE
SETTING CONTROLS
THE WORD AUTO The sensor is clogged or faulty.
DOESN’T APPEAR
Try using the below steps to clear the sensor:
IN THE DISPLAY
1. Remove all metal utensils from the dishwasher.
2. DO NOT ADD DETERGENT.
3. Select POTS PANS cycle and ENERGY SAVER DRY off.
4. Start the dishwasher and allow to run until the time remaining in the cycle appears in
the display.
5. Then open the door and pour 1/4 cup of citric acid crystals into the bottom of the
dishwasher. (Most drugstores carry citric acid crystals. If yours doesn’t, call GE
Service and Parts Centers.)
6. Close the door and allow the dishwasher to complete the cycle.
If the problem continues call for service.
DISHWASHER A fuse in your home may be blown, or the circuit breaker tripped. Replace fuse or
WON’T RUN reset circuit breaker. Remove any other appliances from the circuit.
UNUSUAL NOISE Utensils may not be secure on rack pins, or something small may have dropped from
the rack. Water is causing utensils to rattle. Make sure everything is securely placed
in dishwasher.
Water draining out of tub immediately after you touch RESET pad. The sounds you
hear are normal ones.
DISHES DON’T DRY Make sure inlet water temperature is correct. (To test, see How to Test Water
Temperature section.)
Unload the bottom rack first. Water from dishes in the top rack may be spilling
onto the bottom rack.
Check for improper loading. Dishes shouldn’t nest together. Avoid overloading.
Check the rinse agent dispenser to see that it’s not empty.
Choose another cycle to give you longer washing time.
UNCLEAN DISHES Check inlet water temperature. It should be at least 120°F. (To test, see How to
AND FLATWARE Test Water Temperature section.)
Water pressure may be temporarily low. Turn on a faucet. Is water coming out slower
than usual? If so, wait until pressure is normal before using your dishwasher.
Plugged air gap. (See Care and Cleaning section.)
Improper rack loading. (See Loading section.)
Choose another cycle to give you longer washing time.
Make sure the area in and around the vent is clear.
20
QUESTIONS?
USE THIS PROBLEM SOLVER