GE Monogram ZBD3500, Инструкция по использованию и уходу

Страница: 10 / 28

DISPLAY WHAT IT MEANS WHAT TO DO
Electrical power to the dishwasher IF DISHWASHER WAS IN USE WHEN THE POWER
has been interrupted but is now FAILURE OCCURRED:
back on.
1. Press the RESET pad and wait approximately 30 seconds.
RESET
2. Unlatch and open the door.
A) If the detergent cup is open and empty and the
dishwasher was set for the NORMAL, POTS PANS
or CHINA CRYSTAL cycle, close door and put the
load through a RINSE HOLD cycle. After the RINSE
HOLD cycle is completed, add detergent and reset the
load for the washing cycle you want.
B) If the detergent cup is closed and the dishwasher was set
for the NORMAL, POTS PANS or CHINA CRYSTAL
cycle, reset the dishwasher for the wash cycle you want.
C) If the dishwasher was set for the RINSE HOLD cycle,
reset the dishwasher for RINSE HOLD.
IF THE DISHWASHER WAS NOT IN USE when power
failure occurred, use dishwasher as you normally would.
Slow draining. The dishwasher is This dishwasher is designed to automatically compensate
taking longer than normal to drain for longer than normal drain times, but cycle time will be
the water out. This is usually caused extended. If this code continues to appear frequently:
by a blockage in the drain air gap
1. Clean the air gap (See Air Gap section).
(see Air Gap section), a kink in the
2. Check for a kink in the drain hose.
drain hose, or a stopped-up pipe.
3. Check plumbing for slow or stopped-up drains. (NOTE:
Warranty service does not cover household drain problems.)
Drain is blocked. Similar to slow Press the RESET pad to stop the beep.
drain. This indicates that the drain
Locate and remove the blockage in the drain system.
RESET
is so clogged that the dishwasher
To pump any remaining water out of the machine:
cannot continue to operate in a
1. Latch door.
satisfactory manner. Dishwasher
2. Select any cycle.
will stop.
3. Touch “START” and then immediately touch RESET.
(NOTE: Warranty service does not cover household
drain problems.)
Drain sensor is not functioning. If repeats for the next cycle, call for service.
Dishwasher will continue cycle
along with a fixed drain period.
There is too much water in Press the RESET pad to stop the beep.
the dishwasher.
The dishwasher is designed to automatically pump out
RESET extra water as long as the door is latched. When you hear
the motor stop running:
1. Unlatch the door and see if all the water is gone.
2. If you see water entering the dishwasher, close and latch
the door. Shut off the water supply to the dishwasher.
3. If water is gone and no water is entering the dishwasher,
restart cycle.
4. If repeats, shut off the water supply to the
dishwasher. Call for service.
THE DISPLAY TELLS YOU IF CERTAIN
THINGS ARE WRONG
10