GE Monogram ZBD3500, Инструкция по использованию и уходу

Страница: 13 / 28

13
To get dishes clean and dry, you need hot water. For good washing and drying,
the entering water must be at least 120°F. To prevent dish damage, inlet water should not exceed 150°F.
Good Dishwashing Starts with HOT Water
How to Test Water Temperature
Check your water temperature with a candy or meat
thermometer. Turn on the hot water faucet nearest
the dishwasher. Put the thermometer in a glass and
let the water run continuously into the glass until the
temperature stops rising. If the water temperature is
below 120°F., adjust your water heater.
Helpful hints: If outside temperatures are unusually
low, or if your water travels a long distance from water
heater to dishwasher, you may need to set your water
heater’s thermostat up. If you have not used hot water
for some time, the water in the pipes will be cold. Turn
on the hot water faucet at the sink and allow it to run
until the water is hot. Then start the dishwasher. If
you’ve recently done laundry or run hot water for
showers, give your water heater time to recover before
operating the dishwasher.
The rinse agent makes water flow off dishes
quicker than usual. This lessens water spotting
and makes drying faster, too.
For best dishwashing performance, use of a rinse
agent such as JET-DRY brand is recommended.
Rinse agents come in either liquid or solid form.
Your dishwasher uses the liquid form.
How to fill the rinse agent dispenser.
Unscrew the cap.
Add liquid rinse agent
until it just reaches the
bottom of lip inside the
dispenser opening.
Replace cap. The
dispenser automatically
releases rinse agent into
final rinse water.
You may check to see if you need to add rinse agent by
removing the fill cap and looking into the container.
You may also check the rinse agent by pressing the
clear center of the fill cap 2 or 3 times. If rinse agent is
drawn into the center of the fill cap, you have enough.
If the center area remains clear add rinse agent.
Your dishwasher’s rinse agent container holds
approximately 4
1 ⁄
2
ounces. This should last about
3 months. Fill as needed.
If you accidentally spill: Wipe up the rinse
agent with a damp cloth. Don’t leave the spill in the
dishwasher. It can keep your detergent from working.
If you can’t find any rinse agent, write:
BENCKISER CONSUMER PRODUCTS, INC.
(‘‘JET-DRY’’)
Corporate Centre 1
55 Federal Road
P.O. Box 1991
Danbury, CT 06813-1991
How to Use a Rinse Agent
Forget to Add a Dish?
Add dishes any time during the RINSE & HOLD
cycle. With other wash cycles, you can add dishes at
any time BEFORE the main detergent wash portion of
the cycle.
However, opening the door during any cycle
lessens cleaning power. So try to load everything
at the beginning.
Here’s how to add a forgotten dish:
1. Push the door latch to the left. Washing will stop.
2. Wait a few seconds until the water calms. Then
open the door. WARNING: Hot vapor may rise
from the opened door.
3. Add dishes you’ve forgotten.
4. Close the door and push the latch to the far right.
When the door is locked, washing will continue.
NOTE: If you forgot to latch the door a reminder
signal will beep until you do so.