05-2806A01, Rev. L
MDS iNET Series Reference Manual
135
NOTE:
Configuration of the iNET/ENI can be accomplished using the same two methods that function
with Rockwell’s ENI module:
1. With Rockwell ENI configuration utility connected to COM2 of the iNET/ENI.
2. Via EtherNet/IP using commands and structures listed for ENI in the 1761-NET-ENI User
Manual.
In addition to these methods, configuration may also be performed using the standard user inter-
face of the iNET transceiver and following through the Serial Port Configuration Wizard for DF1
to EtherNet/IP.
DF1/EIP PROTOCOL CONFIGURATION
NOTE:
The Rockwell application will not identify the iNET/ENI radio properly unless the EDS file has
been integrated the application using RSlinx software. If this has not already been done, refer to
“EDS File Integration” on Page 145 for more information.
Perform the following procedure to configure the
DF1/EIP
IP protocol settings:
1. Press
A
if you want to change Security Descriptor Mask 1 from its default of
0.0.0.0
Security Descriptor Mask 1 was changed to
192.158.16.255
.
Press
B
if you want to change Security Descriptor Mask 2.
2. Press
N
to continue.
Use the Security Descriptor Mask to control which IP addresses can access the serial device connected
to the iNET/ENI. Values of 0 and 255 are considered “open,” meaning any value in that position of the
IP address is accepted. For example, the default value of
0.0.0.0
(or a value of
255.255.255.255
) would
allow any IP address to access the device. In Figure A-3, only IP addresses beginning with 192.158.16
can access the device.
NOTE:
The IP addresses shown in this manual are for example only. See your network administrator to
determine the actual values you should use.
When using COM1, you must specify an expanded path to the target. To send a message to
COM1, enter the following path:
<INET/ENI IP Address>, 1, 1
where
1
is the COM1 output port and
1
is the destination address of the connected DF1 device.
Содержание MDS iNET Series
