11
REMOVE DUCT KNOCKOUT(S)
If recirculating, non-vented ductless (optional for
JV5 Series models only), see note below and skip to
Step 9 D and proceed. The JV6 Series models cannot be
recirculated.
Using a flat blade screwdriver, remove the appropriate
duct knockout(s)
from the top or back of the hood.
3
1
ø
4
”
x 10
”
Rectangular
vertical discharge.
Remove top rectangular
duct knockout only.
”
Round vertical discharge.
Remove semi-circular duct
knockout and top rectangular
duct knockout.
3
1
ø
4
”
x 10
”
Rectangular horizontal
discharge.
Remove rear
rectangular duct knockout only.
FOR 3
1
ø
4
”
x 10
”
RECTANGULAR
DUCTED DISCHARGE INSTALLATIONS
ONLY:
Attach
H[KDXVWDGDSWRUGDPSHU
over knockout
RSHQLQJZLWKWZRH[KDXVWDGDSWRUVFUHZV0DNHVXUH
damper
pivot
is nearest to
WRSEDFNHGJH
of hood.
Remove
tape
from damper flap.
Up to 1
”
side-to-
side adjustment
Tape
Top/back edge
([KDXVWDGDSWRUGDPSHU
(vertical discharge
position shown)
Pivot
)25
”
ROUND VERTICAL DUCTED
DISCHARGE INSTALLATIONS ONLY:
5HLQVWDOOWKH
”
round exhaust adaptor
with its
screws, removed in Step 2 under the “Prepare the
Hood” section.
6
8
”
round
H[KDXVW
adaptor
NOTE:
7KH
”
URXQGH[KDXVWDGDSWRUFDQEHLQVWDOOHG
up to 1 inch on either side of the hood center to
DFFRPPRGDWHRIIFHQWHUGXFWZRUN,QH[WUHPHRIIFHQWHU
installations, one end of the duct connector may need
to be trimmed to clear the electrical cable clamp.
127(7KH
”
round damper is not included with
this product. It can be purchased as a kit by calling
800.626.2002. Order kit number JXDA22.
Installation Instructions
NOTE:
7KHH[KDXVWDGDSWRUGDPSHUFDQEHLQVWDOOHG
up to 1 inch on either side of the hood center to
DFFRPPRGDWHRIIFHQWHUGXFWZRUN,QH[WUHPHRIIFHQWHU
installations, one end of the duct connector may need to
be trimmed to clear the electrical cable clamp.
NOTE:
If the hood is to be installed in a recirculating, non-
vented ductless manner, order charcoal filters,
NLWQXPEHU:%;IRU
”
hood models, or
NLWQXPEHU:%;IRU
”
hood models.
These kits can be ordered from your GE supplier.
Skip to Step 9 D and proceed.