GE JS998 Series, Техническое обслуживание руководство

Страница: 16 / 77

– 16 –
Trivection
TM
Door Assembly
WARNING: A microwave leakage test must be
performed any time a door is removed, replaced,
disassembled, or adjusted for any reason.
The
maximum leakage is 4 MW/cm
2
(see
Microwave Leakage Test).
Caution: The door is very heavy. Use the correct
lifting procedures. Do not lift the door by the
handle.
To remove the Trivection
TM
door:
1. Fully open the door.
2. Remove the security screws and clips on
each hinge with a Torx 20 (T20) screwdriver.
3. Pull the hinge locks down toward the door
frame, to the unlocked position. (This may
require a flat-blade screwdriver to start the
hinge locks moving).
4. Firmly grasp both sides of the door at the top.
5. Close the door to the door removal position,
which is halfway between the broil stop
position and fully closed.
6. Lift the door up and out until the hinge arm is
clear of the slot.
Note: There is no gap at the bottom of the gasket
on the Trivection
TM
oven door.
To remove the inner glass assembly:
1. Remove the eight
1
/
4
-in. hex head screws
holding the insulation retainer.
2. Remove the retainer and insulation.
3. Lift the inner glass assembly off the inner
door.
Cross the gasket and tuck loose ends into the
slots at the bottom of inner panel as shown below.
Caution: Care must be taken if reinstalling the
door handle. Overtightening screws can damage
handle. Hand-tighten screws and make sure
handle fits snugly to door panel (do not use
electric driver).
To remove the Trivection
TM
Door Gasket:
The door gasket is attached to the inner door
panel by spring clips. In addition to being a self-
clean gasket, the door gasket has a wire mesh to
help seal microwave energy.
To remove the outer door:
1. Place the inner door side down on the work
area.
2. Remove the eight T15 Torx screws from the
outer door (two on each side, four across the
bottom).
3. Lift the outer door and handle off the door
assembly.