![GE JKS10 Скачать руководство пользователя страница 8](http://html.mh-extra.com/html/ge/jks10/jks10_owners-manual_129991008.webp)
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
8
Using the clock, timer and control lockout.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during timed
baking.
Press the
Clock
pad.
Press the
Hour
and
Min +
or
–
pads to set the time of day.
Press the
Start
pad.
Make sure the clock is set to the
correct time of day.
To Set the Timer
Press the
Kitchen Timer On/Off
pad.
Press the
Hour
and
Min +
or
–
pads until the amount of
time you want shows in the display.
If you make a mistake, press
Kitchen Timer On/Off
and begin
again.
Press the
Start
pad.
After pressing the
Start
pad,
SET
disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
When the timer reaches
:00
, the
control will beep 3 times followed
by one beep every 6 seconds until
the
Kitchen Timer On/Off
pad is
pressed.
The 6 second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by pressing
the
Kitchen Timer On/Off
pad, then press
the
Hour
and
Min +
or
–
pads until the
time you want appears in the display.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing the
Kitchen Timer On/Off
pad and
then pressing the
Hour
and
Min +
or
–
pads to enter the new time you want.
To Cancel the Timer
Press the
Kitchen Timer On/Off
pad twice.
Control Lockout
Your control will allow you to lock out the touch
pads so they cannot be activated when pressed.
To lock/unlock the controls:
Press the
Hour
and
Min –
pads at the
same time for 3 seconds until the
display shows
LOC ON
.
To unlock the control, press the
Hour
and
Min –
pads at the same
time for 3 seconds until the display
shows
LOC OFF
.
When this feature is on and the touch
pads are pressed, the control will beep
and the display will show
LOC ON
.
■
The control lockout mode affects all touch
pads. No touch pads will work when this
feature is activated.
■
The adjustment will be retained in memory
after a power failure.