HOW TO CONVERT THE RANGE FOR USE
GAS OR NATURAL GAS
(continued)
❑
CONVERTING SURFACE BURNERS
Burner Head
‘crew’~
<i
’”1
Gas Inlet Tube
1. Remove the grates and burner heads.
2. Using the
remove the burner bases
by unscrewing the 3 small screws in each base.
the burner straight out.
DO
disconnect the wires from the burner
bases unless the
needs to be raised.
3. Remove the brass orifice spud under each
burner base by unscrewing spud from fitting
with a
or small adjustable wrench
(depending on the size of your’ spuds).
a
3/4” wrench to the hex on the gas inlet tube
as a back-up when removing spud to prevent
the aluminum from twisting.
4. Install
spuds according to one of
the following diagrams (see
❑
or
❑
), for
gas or natural gas, depending on which you
converting to.
❑
Orifice Spuds for
orifice spuds are in a small plastic bag packed
with this Use and Care Guide.
orifice spuds
have a 2-digit number and the letter “L” on one
side. Each
spud will also have 1 or 2
grooves on one side, denoting the location on the
range where it is to be installed as shown below.
❑
Orifice Spuds for
Natural Gas:
Natural gas
spuds have a 3-digit number
on one side. Each
spud will also have 1, 2
or 3 grooves on one side, with the letter “N”
underneath denoting the location on the range
where it is to be installed as shown below.
34
