❑
A risk of range
if the
is not
in accordance with the
initiation instructions provided.
proper
use of this device
the risk of
In using this
consumer must
observe the safety instructions as stated in
the USE and
and avoid
the
oven door and/or lower drawer as a step stool.
instructions are provided for wood
and cement in
floor or
Any other
of construction may require special
techniques as deemed necessary to provide
adequate fastening of the
bracket to
the floor or
anti-tip device
with
range does not fit this application, use
the universal anti-tip device
Step
Bracket
Mark the floor or
where either the right
or left ‘EDGE” of the
opening is to
be
B. Place the
see figure 1,
inch from the marked “EDGE” toward center
of opening and against the back
C. Use the bracket as a template and mark the
required holes, as shown in figure 1, for the
type of construction you
be using.
Step
Bracket
Construction:
1.
the center of the 2 holes identified in
figure 1 as
a l/&inch
pilot hole in the center of each hole (a nail or
awl may be used if a
is not
Secure the
bracket to the floor
the 2 screws provided. Proceed to Step 3.
2.
the
center of the 2 holes identified in
as
angled
inch
hole in the center of each hole as
shown in&e 2. (And or awl maybe used if
a
is not
Secure the
bracket to the
with the 2 screws provided
as shown in figure 2. Proceed to Step 3.
B. Cement or
Construction:
1. Suitable screws for concrete construction
can be obtained at the hardware store.
the required
hole for the hardware
into the concrete at the center of
the holes
in figure 1 as
Secure the
bracket to
the floor. Proceed to Step 3.
Step
Complete the initiation of the range per
the initiation instructions provided with
the
B.
the range to
designated location and
shale it back into position.
A minimum
clearance of 5/&inch is required between the
range and the
foot that will engage
the
see figure 2.
C. For
as
as
optimum performance adjust the range so
that it is level.
maybe checked by
a level or a large pan of water on the
or the oven rack. an adjustment
is required
the range forward, tip the
range and rotate the level feet as required.
D. To check
range for proper instigation of
the
use a
and
look underneath
bottom of the range to
see that one of the rear
legs is
engaged in the bracket
E. Proceed
the remainder of the initiation
instructions provided with
range.
FIGURE ONE
FIGURE
