NOTE:
The glass cover (on some models) should be
removed only when cold. Wearing latex gloves may
offer a better grip.
CAUTION
:
Before replacing your oven light
bulb, disconnect the electrical power to the oven
at the main fuse or circuit breaker panel.
Be sure to let the light cover and bulb cool
completely.
For your safety, do not touch a hot bulb with bare
hands or a damp cloth.
To remove:
Turn the glass cover counterclockwise 1/4
turn until the tabs of the glass cover clear the
grooves of the socket.
Using gloves or a dry cloth, remove the bulb
by pulling it straight out.
To replace:
Use a new 130-volt halogen bulb, not to
exceed 50 watts.
Using gloves or a dry cloth, remove the bulb
from its packaging. Do not touch the bulb
with bare fingers.
Push the bulb straight into the receptacle all
the way.
Place the tabs of the glass cover into the
grooves of the socket. Turn the glass cover
clockwise 1/4 turn.
For improved lighting inside the oven, clean
the glass cover frequently using a wet cloth.
This should be done when the oven is
completely cool.
Reconnect electrical power to the oven.
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
www.geappliances.ca
13
Do not allow food spills with a high
sugar or acid content (such as
tomatoes, sauerkraut, fruit juices or
pie filling) to remain on the surface.
They may cause a dull spot even
after cleaning.
To clean the inside of the door:
■
Soap and water will normally do the job. Heavy
spattering or spillovers may require cleaning with
a mild abrasive cleaner. Soap-filled steel wool pads
may also be used.
If necessary, you may use an oven cleaner. Follow the package
directions.
■
Clean the inside of the oven window with a mild
non-scratching cleaner and a damp cloth.
To clean the outside of the door:
■
Use soap and water to thoroughly clean the top,
sides and front of the oven door. Rinse well. You
may also use a glass cleaner to clean the glass on
the outside of the door. Do not let water drip into
the vent openings.
■
Spillage of marinades, fruit juices, tomato
sauces and basting materials containing acids
may cause discoloration and should be wiped up
immediately. When surface is cool, clean and
rinse.
■
Do not use oven cleaners, cleaning powders or
harsh abrasives on the outside of the door.
The door is very heavy. Be careful when removing and
lifting the door.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
Pull the hinge locks down toward the door
frame, to the unlocked position. A tool, such
as a small flat-blade screwdriver, may be
required.
Firmly grasp both sides of the door at the top.
Close door to the door removal position,
which is halfway between the broil stop
position and fully closed.
Lift door up and out until the hinge arm is
clear of the slot.
To replace the door:
Firmly grasp both sides of the door at the top.
With the door at
the same angle
as the removal
position, seat the
indentation of
the hinge arm into the
bottom edge of the
hinge slot. The notch in the hinge arm must
be fully seated into the bottom of the slot.
Fully open the door. If the door will not fully
open, the indentation is not seated correctly
in the bottom edge of the slot.
Push the hinge locks up against the front
frame of the oven cavity, to the locked
position.
Close the oven door.
Lift-Off Oven Door
Removal position
Indentation
Bottom
edge
of slot
Hinge lock
Slot
Pull hinge locks down to unlock.
Hinge lock
Push hinge locks up to lock.
Hinge arm
Hinge
arm
Bulb
Socket
Tab
Glass cover
Receptacle
Use gloves
or cloth
Receptacle
Oven Light Bulb
Содержание JCKS06
Страница 18: ...18 ...
