GE JCAS745, Руководство пользователя и инструкции по установке, Страница: 39 / 46

39
Problem
Oven temperature too
hot or too cold
Clock and timer do not
work
Display goes blank
Oven door is crooked
Display flashes
Unable to get the
display to show “SF”
Power outage
Oven makes clicking
noise
“F-and number or
letter” flash in the
display
Possible Causes
Oven thermostat
needs adjustment.
Plug on range is not completely
inserted in the electrical outlet.
A fuse in your home may be
blown or the circuit breaker
tripped.
The door is out of position.
Power failure.
Oven control pads were not
pressed properly.
Power outage or surge.
This is the sound of the heating
element turning off and on
during cooking functions.
You have a function error code.
The clock is turned off from
showing in the display.
If the function code repeats:
A fuse in your home may be
blown or the circuit breaker
tripped.
Oven controls improperly set.
What To Do
See the
Adjust the oven thermostat-Easy to do
yourself! Section
Make sure electrical plug is plugged into a live, properly
grounded outlet.
Replace fuse or reset circuit breaker.
See the Using the clock, timer and convenience outlet
section.
Replace fuse or reset circuit breaker.
Because the oven door is removable, it sometimes gets
out of position during installation. To straighten the
door, push down on the high corner.
Reset the clock.
The
BAKE
and
BROIL
pads must be pressed at the same
time and held for 3 seconds.
Some models will automatically resume their setting
once the power is restored. On models with a clock, you
must reset the clock. If the oven was in use, you must
reset it by pressing the
OFF
pad, setting the clock and
resetting any cooking function.
This is normal.
Press the OFF pad. Put the oven back into operation.
See the Using the clock, timer and convenience outlet
section.
Disconnected all power to the range for at least 30
seconds and then reconnect power. If the function error
code repeats, call for service.
On self-cleaning models, if a function error code
appears during the self-cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, from the locked position. Make sure the latch is
moved to the right as far as it will go. Press the OFF pad.
Allow the oven to cool for one hour. Put the oven back
into operation.
Consumer Support
Troubleshooting Tips
Care and Cleaning
Safety Instructions
Installation
Instructions
Operating
Instructions
Troubleshooting Tips
Before you call for service...