SPS J2007003 L064 - Quick Start Guide
Document 850047442 r01 2015 July
1
Step 10 - Configure Controller per Galaxy Pulsar Edge Controller Quick Start Guide
1. Verify and edit controller basic configuration parameters per site engineering instructions.
2. Con24V Alarm Input per site engineering instructions - see
Information: Controller - Configure Alarm Inputs and Outputs
.
3. Configure Converter Alarm Outputs per site engineering instructions - see
Information: Controller - Configure Alarm Inputs and Outputs
.
Step 8 - Install Converters
Firmly push the converter into the converter slot.
Tighten the thumb screw until the converter is seated.
NOTE: When installing a converter in a powered system the RUN LED on the converter will
blink until communication with the controller is established.
Step 9 - Initial Start Up
Verify that all DC and Alarm connections are complete and secure.
If there are no alarms, make required adjustments to the default settings on the controller for this installation.
Information: Controller - Configure Alarm Inputs and Outputs
Converter Alarm Outputs:
1. Select the
Settings
tab > Power >
Converters
to set alarm thresholds, severity and relays on J1 connector.
2. Select the drop down arrow next to the LED field and select ALM to activate the ALM LED for that alarm
condition.
Factory defaults are shown in the web page to the right.
Converter Alarm Outputs:
Settings tab > Converters
3
+24V Breaker Alarm Input:
1. Select the
Settings
tab > Programming > Auxiliary Inputs
Converters
to configure the +24V Alarm
Input.
2. Select “Click to Edit Assoc. Alarm” select button to the right of J2.3.
3. Select the drop down arrow next to the LED field and select ALM to activate the ALM LED for that
alarm condition.
4. Select the drop down arrow next to the Relay field and select ALM to activate the ALM Relay for
that alarm condition.
5. Edit the Descriptions as instructed.
6. Select Submit to save.
Factory defaults are shown in the web page to the right.
