9
Plug
button
Hinge cover
Plug buttons
or screws
Hinge
2-Door Reversal (on some models)
1 . Remove the small plug button on the left
side of the door top cap .
2 . Remove the 2 plug buttons or screws on
the left side on top of the cabinet .
3 . Remove the plastic hinge cover by lifting
it up by the front edge .
4 . Remove the 2 screws from the top hinge .
5 . Lift the freezer door up and off the middle
hinge (right side) . Set the door on a non-
scratching surface with the outside up .
6 . Remove the center hinge by removing
the 2 screws . Lift the hinge to remove .
7 . Lift the fresh food door off of the bottom
hinge . Set the door on a non-scratching
surface with the outside up .
8 . Tilt the refrigerator cabinet back to
remove the left leveling leg .
9 . Remove the screws on the bottom hinge
(right side) and remove the leveling leg .
Move the bottom hinge to the left side
and secure it with screws . Re-install the
leveling legs .
IMPORTANT:
The left leg has a spacer or
spacer feature that must be moved to the
right side leveling leg when the door swing
is reversed.
10 . Screw the right leveling leg, with the
spacer, back in place on the right side .
11 . Remove the two plug buttons on the left
side at the center and install them on the
right .
12 . Position the door on the left bottom
hinge . With the magnetic gasket holding
the door in place, make sure the door is
aligned with the refrigerator, and secure
the center hinge on the left with screws .
13 . Place the freezer door on the center hinge
over the pin . Assure the door is aligned
horizontally and vertically, and that the
gasket seals on all sides .
14 . Replace the top hinge on the left side with
screws .
15 . Replace the hinge cover on top of the
hinge .
16 . Put the plug button in the hole on the
right side of the door cap .
17 . Put the 2 plug buttons on the right side
on top of the cabinet
Plug
buttons
Leveling legs
Bottom
hinge
Spacer
Center
hinge
Screws
Installation Instructions